Click above to get retro games delivered to your door ever month! CHANGING RADII AND LINE TYPES IN CIRCLES The Line Type command specifies a line pattern to be used when drawing lines. You can specify the line type, pattern length and the mode. The line type specifies a particular pattern, the pattern length specifies the length of one complete line pattern, and mode specifies how the values of the pattern length parameter are interpreted. For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1 (black). Even though there is no physical pen, the SP command must be used to enable printing. SC-75,75,-75,75,1; Sets up user scaling with (-75,-75) as P1 and (75.75) as P2; the "1" parameter specifies isotropic scaling. PA0,0; Specifies absolute plotting and moves to user-unit location (0,0). LT;CI5; Specifies a default line type (solid) and draws a circle with a radius of 5 user-units. LT0;CI-12; Selects line type 0 (dotted) and draws a circle with a radius of 12 user-units (the -sign indicates starting at the 180 degree point). LT1;CI19;LT2;CI-26; Selects line type 1, and draws a circle with a radius of 19 user-units. then selects line type 2 and draws a circle with a radius of 26 user-units. LT3;CI33;LT4;CI-40; Selects line type 3, draws a circle with a radius of 33 user-units, then selects line type 4 and draws a circle with a radius of 40 user-units. LT5;CI47;LT6;CI54; Draws the outer two circles; the first with line type of 5 and radius of 47 user-units; the second with line type of 6 and a radius of 54 user- units. Ec%0A Enters PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.