Click above to get retro games delivered to your door ever month! DRAWING CIRCLES The CI command uses your current pen position as the center of the circle; you specify the radius of the circle. For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] Esc] in DOS EDIT EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2. SP1; Selects pen number 1, (black). The SP command must be used to enable printing. PA2400,2500; Specifies absolute plotting and moves to position (2400,2500). CI500; Draws a circle with a radius of 500 plu (plotter units); the center of the circle is the current pen location (2400,2500). Ec%0A Enters the PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.