Click above to get retro games delivered to your door ever month! USING THE PLOT RELATIVE COMMAND The Plot Relative command establishes relative plotting and moves the pen to specified points, with each move relative to the current pen location. For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT. EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1, (black). Even though there is no physical pen, the SP command must be used to enable printing. PA10,10;PD Begins absolute plotting from coordinate (10,10), and places the pen down. PR2500,0,-2500,1500,0,-1500; Specifies relative plotting and draws lines beginning at (10,10) and then moves the relative coordinate distances indicated. Ec%0A Enters the PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.