Click above to get retro games delivered to your door ever month! USING THE EDGE POLYGON COMMAND The Edge Polygon ( EP ) command outlines any polygon that is currently in the polygon buffer. This includes wedges and rectangles defined using the EA , ER , EW , RA , RR , and WG commands. EP accesses the data in the polygon buffer, but does not clear the buffer or change the data in any way. For more information see the PCL 5 Printer Language Technical Reference Manual. NOTE: The last polygon drawn is stored in the polygon buffer. This is where EP finds the information it needs to edge a polygon. LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT. EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1, (black). Even though there is no physical pen, the SP command must be used to enable printing. PA2000,10; Selects absolute plotting mode and moves the pen to (2000,10). PM0;PD10,2000,10,10,2000,10;PM1; Enters polygon mode, stores a pen down command, stores points (10,2000), (10,10), and (2000,10), then closes the polygon. PU610,610;CI500;PM2; While still in polygon mode, lifts the pen and moves to (610,610). Draws a circle with a diameter of 500 plu, then closes the current subpolygon and exits polygon mode. EP; Outlines the polygon that was just stored in the buffer. Ec%0A Enters the PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.