Click above to get retro games delivered to your door ever month! USING THE FILL POLYGON COMMAND The Fill Polygon ( FP ) command, fills the polygon currently in the polygon buffer. For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT. EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1, (black). Even though there is no physical pen, the SP command must be used to enable printing. PA1500,1500; Specifies absolute plotting, then moves to (1500,1500). PM0;CI1000,60;PA1500,1500;CI500;PM2; Enters the polygon mode, stores a circle with radius of 1000 plotter units (plu) and a 60 degree chord angle. Stores a pen move to (1500,1500), and another circle with a 500 plu radius and a 5 degree (default) chord angle. Closes the current polygon and exits the polygon mode. LT4;FT3,50,45; Selects line type 4 and fill type 3. Specifies a 50 plu distance between the fill lines, and slants the lines at a 45 degree angle. FP; Using the even-odd fill method, this fills the polygon currently in the polygon buffer with the line and fill types specified in the command above. Ec%0A Enters the PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.