Click above to get retro games delivered to your door ever month! PRINTING LABELS When printing labels in HP-GL/2, use the Label ( LB ) command. For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT. EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1, (black). Even though there is no physical pen, the SP command must be used to enable printing. PA1500,2500; Specifies absolute plotting and moves to (1500,2500). SD1,21,2,1,4,25,5,1,6,0,7,52; Designates the 25 point Universe Italic font as the standard font. DT*,1; Defines the asterisk (*), as the label terminator (the 1 indicates the terminator should not be printed). SA; Selects the alternate font for printing; since an alternate font hasn't been designated, the default 11.5 point stick font is selected. LBThis is the Stick Font (Default)CR-LF CR-LF*; Prints the first line of text, followed by two Carriage Return (CR) and two Line Feed (LF) control codes. Notice how the asterisk terminates the label. SS; Selects the standard font, defined with the SD command above, as a 25 point Universe Italic font. LBThis is Universe Italic*; Prints the next line of text in the newly specified font. Ec%0A Enters PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.