Click above to get retro games delivered to your door ever month! USING THE ABSOLUTE CHARACTER SIZE ( SI ) COMMAND The Absolute character Size ( SI ) command, specifies the size of labeling characters in centimeters. For more information see the Updated PCL 5 Printer Language Technical Reference Manual. The syntax for this command is as follows: SI width, height; or SI; LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT. EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1, (black). Even though there is no physical pen, the SP command must be used to enable printing. PA700,3000; Enters absolute plotting mode and moves to (700,3000). DT#; Defines the label terminator as the "#" character. LBPrint#; Prints the word "Print" in the default font. PA700,2000;SI1,1.5;LBPrint#; Moves to (700,2000); specifies an absolute character size of 1 cm wide by 1.5 cm high; prints the word "Print". SI; Send SI with no parameters to return to the default size. SD1,21,2,1,4,12,5,0,6,0,7, 4148;SS; Designates a 12 point Universe font and selects it. PA 4000,3000;LBPrint#; Moves to (4000,3000) and prints the word "Print" in the 12 point Universe font. PA4000,2000;SI1,1.5;LBPrint#; Moves the pen to (4000,2000) and specifies a character size of 1 cm by 1.5 cm; prints the word "Print". Ec%0A Enters PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.